Delta 37-070 Instruction Manual download pdf (Page 18)

MAINTENANCE

BELT REPLACEMENT

When it becomes necessary to replace the belt on your

jointer, proceed as follows:

1. DISCONNECT THE TOOL FROM THE POWER

SOURCE.

2. Remove screw (A) Fig. 43, using Allen wrench

supplied, and remove belt guard (B).

3. Loosen three screws (C) Fig. 44, to release belt

tension and remove belt (D) from pulleys.

4. Assemble new belt to the cutterhead and motor

pulleys. Press down on motor pulley (E) Fig. 44, to

tension belt and tighten three screws (C).

5. Replace belt guard (B) Fig. 44.

Fig. 43

Fig. 44

1 2 ... 13 14 15 16 17 18 19 20 21

No comments

Delta 37-070 Instruction Manual Page 18