Delta 78-960 Instruction Manual download pdf (Page 15)

Fig. 39

Fig. 40

Fig. 41

6. Fasten the front (F) and rear table (G) supports Fig.

39, to the bottom of the table as shown using four

#8x7/8" long screws (H) supplied. NOTE: The slots

closer to the angles in the supports (F) and (G) should be

against the table. NOTE: Holes (I) Fig. 39 will not be

fastened to the table board at this time. NOTE: Make

certain the ends of the table supports do not extend out

past the table. The rear support (G) Fig. 39, can be

fastened to the bottom of the table by tightening screws

(H). At this time, however, the screws (H) holding the front

support (F) should not be completely tightened.

CAUTION: DO NOT OVER-TIGHTEN MOUNTING

SCREWS. Over-tightening screws in particle board may

cause them to strip.

7. Assemble Z-brackets (J) Fig. 40, to the inside edge

on right side of extension wing (K) as shown, using three

7/16-20x 3/4" hex head screws, lockwashers, and flat

washers (L). Place lockwasher, washer, z-bracket onto

screw and thread screw from the inside of the extension

wing and tighten securely. NOTE: Using a square (M) Fig.

41, make certain that Z-brackets (J) are perpendicular to

the saw table as shown. Also, lift upward on Z-brackets

while tightening screws to eliminate any play.

8. Fig. 42, illustrates Z-brackets (J) properly assembled

to extension wing.

9. Assemble angle brackets (N) Fig. 43, onto three Z-

brackets (J), two of which are shown, using three 1/4-20

x 3/4" carriage bolts, flat washers and hex nuts (P).

NOTE: The longer leg of angle brackets (N) Fig. 43,

must be secured to Z-brackets (J).

NOTE: Do not completely tighten hardware at this

time.

10. Fig. 44, illustrates angle brackets (N) properly

assembled to Z-brackets (J).

Fig. 42

Fig. 43

Fig. 44

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

No comments

Delta 78-960 Instruction Manual Page 15