Delta DJ-15 Instruction Manual download pdf (Page 14)

FENCE OPERATION

The fence can be moved across the table by loosening

lock lever (A) Fig. 30, move the fence to the desired

position, and tighten lock lever (A) securely. As the fence

is moved across the table, the sliding portion of the

fence bracket (F) guards the cutterhead in back of the

fence as shown.

Fig. 30

To tilt the fence to the right or left, loosen handle (B)

Fig. 31, pull out plunger (C) and using the fence tilting

lever (D), move the fence to the desired angle and

tighten handle (B) securely. NOTE: The handle (B) Fig.

31, is spring-loaded and can be repositioned by pulling

out the handle and repositioning it on the serrated nut

located underneath the handle. IMPORTANT: When

cutting a bevel, we suggest that whenever possible the

fence be tilted toward the table, as shown in Fig. 32. The

fence will then form a V-shape with the tables, and the

work is easily pressed into the pocket while passing it

across the knives.

Fig. 31

Fig. 32

ADJUSTING FENCE

POSITIVE STOPS

The fence on your jointer is equipped with positive stops

at the most used fence positions of 90 degrees and 45

degrees right and left. To check and adjust the positive

stops, proceed as follows:

DISCONNECT MACHINE FROM

POWER SOURCE.

1. Position the fence 90 degrees to the table by making

sure end of plunger (A) Fig. 33, is engaged in notch in

index collar (B), as shown, and tighten lockhandle (C).

Fig. 33

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

No comments

Delta DJ-15 Instruction Manual Page 14