Delta DJ-15 Instruction Manual download pdf (Page 9)

ASSEMBLING MOTOR

PULLEY

Assemble motor pulley (K) Fig. 7A, to motor shaft with

the hub of the pulley in the outer position as shown.

Make certain key (L) is inserted in the keyway of the

pulley and motor shaft, then tighten set screw (M) using

the 2.5 mm hex wrench (not shown). NOTE: THE KEY

(P) FIG. 7, FOR THE MOTOR PULLEY, IS TAPED TO

THE MOTOR HOUSING.

Fig. 7

ASSEMBLING BELT AND

ALIGNING PULLEYS

1. Place belt (A) Fig. 8, in groove of cutterhead pulley

(B) and motor pulley (C).

2. Make certain the motor pulley (C) Fig. 8, is properly

aligned with cutterhead pulley (B) by placing a straight

edge (D) Fig. 8, onto the face of each pulley as shown.

3. If an adjustment is needed, the motor pulley can be

moved in or out on the motor shaft, or the motor can be

shifted by loosening motor mounting screws, two of

which are shown at (E) Fig. 8. After adjustments are

made, tighten motor mounting hardware and motor

pulley set screw.

Fig. 8

ADJUSTING BELT TENSION

1. Correct belt tension is obtained when there is

approximately 1" deflection at the center span of the

belt using light finger pressure.

2. If an adjustment is required, the motor can be raised

or lowered to obtain the correct belt tension.

3. Tighten motor mounting hardware after tension is

applied, making sure alignment of the pulleys is not

disturbed.

4. Re-attach back panel of stand which was removed

in STEP 1 of “JOINTER TO STAND”.

ASSEMBLING CUTTERHEAD

PULLEY/BELT GUARD

1. Align the two holes in the cutterhead pulley/belt

guard (A) Fig. 10 with the two holes (B) in the top of the

stand.

2. Place a 1/4" flat washer on an 1/4-20x5/8" hex head

screw, and insert the screw through the hole in the

cutterhead pulley/guard (A) and the hole (B) in the top of

the stand. Thread a 1/4-20 hex nut onto the screw and

tighten securely. Repeat this process for the remaining

hole in the cutterhead pulley/belt guard.

Fig. 10

Fig. 7A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Delta DJ-15 Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Power tools Delta DJ-15