Delta DP200 Instruction Manual download pdf (Page 11)

LOCKING SWITCH IN

THE “OFF” POSITION

IMPORTANT: When the machine is not in use, the

switch should be locked in the “OFF” position to prevent

unauthorized use. This can be done by grasping the

switch toggle (B) and pulling it out of the switch, as

shown in Fig. 19. With the switch toggle (B) removed,

the switch will not operate. However, should the switch

toggle be removed while the drill press is operating, the

switch can be turned “OFF” once, but cannot be

restarted without inserting the switch toggle (B).

Fig. 19

TABLE ADJUSTMENTS

1. The table can be raised or lowered on the drill press

column by loosening the table clamp (A) Fig. 20, and

turning the table raising and lowering handle (B) Fig. 21.

After the table is at the desired height, tighten clamp (A)

Fig. 20. NOTE: Final positioning of the drill press table

should always be from the bottom to the up position.

2. The table can be rotated 360 degrees on the column

by loosening clamp (A) Fig. 20, rotate table to desired

position and tighten clamp (A).

Fig. 20

Fig. 21

Fig. 19A

FLEXIBLE LAMP

The flexible lamp operates independently of the drill

press. To turn the lamp “ON” and “OFF”, rotate switch

(A) Fig. 19A.

WARNING: To reduce the risk of fire, use 40 watt or

less, 120 volt, reflector track type light bulb (not

supplied). A standard household light bulb should not be

used. The reflector track type light bulb should not

extend below the lamp shade.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta DP200 Instruction Manual Page 11