Delta DP200 Instruction Manual download pdf (Page 9)

Fig. 12

Fig. 13

Fig. 14

7. Thread stud on clamp handle (M) Fig. 12, into hole in

rear of table bracket, as shown.

8. Place the drill press head (N) Fig. 13, onto the

column as far as it will go. Align head (A) Fig. 13A, to

table (B), and base (C). Tighten the two head locking

screws (O) Fig. 13, with wrench supplied.

9. Thread the three pinion shaft handles (P) Fig. 14, into

the three tapped holes located in the pinion shaft, as

shown.

Fig. 13A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta DP200 Instruction Manual Page 9