Delta GR150 Instruction Manual download pdf (Page 10)

Fig. 7

2. Align the holes in the eye shield with the holes in the spark guard and place the eye shield bushing (A) Fig. 7, in

between the space in the spark guard.

3. Insert the eye shield bolt (A) Fig. 8, through the hole in the eye shield (B), eye shield bushing (C), and spark guard (D).

4. Place an 6.4mm flat washer (E) Fig. 8, onto the end of the eye shield bolt and fasten the eye shield knob (F) to the

end of the eye shield bolt.

5. Assemble the other eye shield in the same manner.

Fig. 8

FASTENING GRINDER TO

SUPPORTING SURFACE

Fig. 9

If, during operation, there is any

tendency for the grinder to tip over, slide, or “Walk”,

the grinder must be secured to the supporting

surface using fasteners (not supplied) through the

two holes (A) Fig. 9 in the grinder base.

STARTING AND STOPPING GRINDER

The switch (A) Fig. 10, is located on the front of the

grinder. To turn the grinder “ON” move the switch right to

the “ON” position. To turn the grinder “OFF” move the

switch left to the “OFF” position.

Fig. 10

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

Make sure that the switch is in the “OFF”

position before plugging in the power cord. In the event

of a power failure, move the switch to the “OFF”

position. An accidental start-up can cause injury.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Frederic P Nelson 04 Mar 2026 | 22:43:26

Don't lie

Delta GR150 Instruction Manual Page 10