Delta GR350 Instruction Manual download pdf (Page 8)

2. Align the holes in the eye shield with the holes in the

spark guard and place the eye shield spacer (A) Fig. 7, in

the space in the spark guard as shown.

3. Insert the eye shield bolt (A) Fig. 8, through the hole

in the eye shield (B), eye shield spacer (C), and spark

guard (D).

4. Place an 1/4" flat washer (E) Fig. 8, onto the end of

the eye shield bolt and fasten the eye shield knob (F) to

the end of the eye shield bolt.

5. Assemble the other eye shield in the same manner.

FASTENING GRINDER TO

SUPPORTING SURFACE

IF DURING OPERATION THERE IS ANY TENDENCY

FOR THE GRINDER TO TIP OVER, SLIDE OR

“WALK,” THE GRINDER MUST BE SECURED TO THE

SUPPORTING SURFACE USING FASTENERS (NOT

SUPPLIED) THROUGH THE TWO HOLES (A) Fig. 9, IN

THE GRINDER BASE.

Fig. 7

Fig. 8

Fig. 9

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND

STOPPING GRINDER

The switch (A) Fig. 10, is located on the front of the

grinder. To turn the grinder “ON” move the switch right to

the “ON” position. To turn the grinder “OFF” move the

switch left to the “OFF” position.

Fig. 10

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Delta GR350 Instruction Manual Page 8