Delta 50-760 User Manual download pdf (Page 9)

9 - English

Place all four stand posts (A) Fig. 3 into the four legs (B)

on the motor/blower assembly. Make sure that the metal

base plate (D) is over the large dust collection hole (C).

ATTACHING THE STAND TO THE MOTOR/BLOWER ASSEMBLY

NOTE: Two people are needed for this step.

Fig. 3

You can assemble this unit with the intake port (B) Fig. 5

in the up position by following the steps in “ATTACHING

THE LEGS TO THE MOTOR/BLOWER ASSEMBLY.”

The difference in constructing the unit is to place the

motor/blower assembly on a flat surface with the motor

(A) Fig. 6 facing up before attaching the legs.

NOTE: Before doing the alternate setup, remove the

5/16” hex head screws from the holes (B) (Fig. 6) and

place them in the holes (C). Air leakage will occur if the

screws are not placed in these holes (C).

ALTERNATE SETUP

The previous steps show you how to assemble the

unit with the motor on top and dust intake ports on the

bottom as shown in Fig 4.

Fig. 4

Fig. 5

Fig. 6

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

No comments

Delta 50-760 User Manual Page 9