Delta 50-850 Instruction Manual download pdf (Page 5)

ASSEMBLY

Fig. 4

Fig. 5

Fig. 6

Fig. 8Fig. 7

ASSEMBLING

CASTERS TO BASE

1. Insert threaded rod of caster (A) Fig. 4, into the hole

located on the underside of base (B) and fasten with

3/8" lockwasher (C) and 3/8-16 hex nut (D). Fig. 5,

illustrates the caster fastened to the base.

2. Assemble the remaining three casters to the

underside of the base in the same manner.

ASSEMBLING BLOWER

AND MOTOR ASSEMBLY

TO BASE

1. Turn base (A) Fig. 6, right side up. Align the

mounting holes at the base of blower and motor

assembly (B) Fig. 6, with six pre-drilled holes (C) in base

(A) and fasten with six 5/16-18x5/8" hex head screws (D)

and 5/16" lockwashers (E).

2. Fig. 7, illustrates the blower and motor assembly (B)

fastened to base (A).

3. Assemble drum support (F) Fig. 8, to the two

threaded holes in the corner of base (A), as shown in

Fig. 8, with two 5/16-18x5/8" hex head screws and

5/16" lockwashers (G). NOTE: Do not completely tighten

hardware at this time.

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE

MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION

MANUAL.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Delta 50-850 Instruction Manual Page 5