Delta A09733 Instruction Manual download pdf (Page 7)

7- ENG

A09733

d. Snap spray

wand (c)

in place

on surface

cleaning

guide

e. Rotate

"J" hook

over spray

wand and

tighten knob

securely.

f. See To Use Spray Wand

paragraph in the Operation

section of this manual to

choose and assemble the

correct nozzle for the job to

be performed.

6. Connect wand to gun. Tighten

securely.

4. Attach high

pressure hose

to gun. Tighten

securely.

3. Place handle assembly onto

frame, depress the snap buttons,

and slide the handle assembly onto

the frame until snap buttons snap

into place.

NOTE: The high pressure pump was

ﬁlled with oil at the factory. The oil in

the high pressure pump was designed

to last the life of the pump. If there is

a problem with the pump contact an

Authorized Service Center.

7. Add engine oil (supplied)

to engine. Refer to Engine

Owners Manual supplied by

engine manufacturer for correct

procedure.

NOTE: There will be a slight amount of

oil in the engine from factory testing.

5. To Assemble "Water Vroom"

surface cleaning guide.

NOTE:

If not using the "Water Vroom"

surface cleaning guide proceed

to step 6.

a. Loosen knob

(a) and rotate

"J" hook (b)

down and

out of the

way.

b. Slide spray

wand (c)

through

opening

in surface

cleaning

guide.

IMPORTANT: Make sure nozzle is

removed before assembling surface

cleaning guide.

c. Adjust spray wand to

desired height needed for

job to be performed.

a

b

c

a

b

c

The shipping plug

must be removed

and replaced with the dipstick/oil

plug before operating pressure

washer.

8. Using an 11/16"

wrench, remove

shipping plug

from pump

by turning it

counterclockwise. Discard plug.

9. Remove dipstick/oil plug from

plastic bag and install into pump,

tighten securely.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Comments to this Manuals

No comments