Delta MS350 Instruction Manual download pdf (Page 13)

You can tilt the cuttinghead of your compound miter saw to cut

any bevel angle from a 90° straight cut off to a 45° left bevel

angle. Loosen the bevel lock handle (A) Fig. 20, tilt the cutting

arm (B) to the desired angle, and tighten the lock handle (A).

Positive stops are provided to rapidly position the saw blade

at 90° and 45° to the table. Refer to the section of this manual

titled “ADJUSTING 90° AND 45° BEVEL STOPS.” The bevel

angle of the cuttinghead is determined by the position of the

pointer (C) Fig. 20 on the scale (D).

A triangle indicator is provided on the bevel scale at the

33.86° bevel angle for cutting crown moulding. Refer to the

“CUTTING CROWN MOULDING” section of this manual.

A rear support bar (A) Fig. 21 is provided to prevent the machine from tipping to the rear when the cuttinghead returns to the up

position. For maximum support, pull the bar (A) out as far as possible.

You can also use the support bar (A) Fig. 22 to carry the machine.

TILTING THE CUTTINGHEAD FOR BEVEL CUTTING

Fig. 20

REAR SUPPORT/CARRYING HANDLE

Fig. 21

Fig. 22

ADJUSTING THE BLADE PARALLEL TO THE TABLE SLOT

1. Lower the cutting arm. The saw blade (A) Fig. 23 should be

parallel to the left edge (B) of the table opening.

2. To adjust, loosen the three bolts (C) Fig. 23 and move the

cutting arm until the blade is parallel with the left edge (B)

of the table opening and centered in the slot. Tighten the

three bolts (C).

DISCONNECT MACHINE FROM POWER SOURCE!

Fig. 23

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

No comments

Delta MS350 Instruction Manual Page 13