Delta SOLIVIA 5.0 Installation Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
EN
21Operation and installation manual SOLIVIA 5.0 AP G3 TR
7.10 Setup / settings
The default display language for solar inverters leaving the Delta factory is set to Eng-
lish.
After connecting to correct DC voltage and running through self-test, you will be asked
to specify the network ID and to select the desired country (countries available: India,
Australia, Australia PL 4.60
1)
and Australia PL 4.99
1)
).
The selection has to be conrmed another time by the user. Once conrmed, the net-
work ID and the country selection are stored to the controller memory – and the solar
inverter is ready for operation.
NOTE
Please note that the enter keys on the display are locked, if there is no
input entry within 5 minutes. The following display message appears:
“Block selection”. To unlock the enter keys, you need to switch off the
DC voltage and then switch it on again (see „9.2 Display messages“,
page 32).
1) In certain states in Australia, power limitation is required.
With power limitation (PL), the output (AC) power of SOLIVIA 5.0 AP G3 TR will be as followed :
Power limitation setting AU PL 4.60 -> Max. power: 4600 W
Power limitation setting AU PL 4.99 -> Max. power: 4990 W
To activate power limitation, please select dedicated country “Australia PL4.60” respectively “Australia PL4.99“ (Installed
settings are password protected):
Select unit ID = [1] & press <ENTER> key
Select country = [Australia PL4.60] or [Australia PL4.99] & press <ENTER> key
Conrm country selection by pressing <ENTER> key
One of the following labels that are enclosed in the box of the inverter MUST be sticked next to the model label:
For Australia PL4.60
This product has been power limited
at maximal output power of: 4.60 kW
For Australia PL4.99
This product has been power limited
at maximal output power of: 4.99 kW
To check if power limitation has been activated, please go to the menu S (Setup) and press the „UP“ or „DOWN“ buttons to
nd the following display message:
S -> Firmware AU PL 4.60
Down
Up
S -> Firmware AU PL 4.99
Down
Up
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Comments to this Manuals

No comments