Delta (Model 31-300) User Manual download pdf (Page 10)

Related Areas: Plaster Area

1. Absolutely no casting or plasterwork is allowed in the shop area or around

powertools. Please mix plaster in the mixing area, and return to your designated

studio area for moldmaking and casting. If you need an area to cast or make

molds, please contact Krista.

2. No casting or plaster work is allowed on tables designated as woodworking or

metal working tables, especially the new worktable in the shop (on wheels).

3. Dust masks are required for use in plaster area.

4. No pre-wash is allowed in sink area or the mixing area. If you're using a pre-

wash system, please use it in your designated studio area and dispose of

accordingly.

5. Do not dispose of wet plaster in water-ﬁlled buckets by sink or mixing area. If

you are using this system to dispose of plaster, do so in your designated studio

area and dispose of accordingly.

6. No wet plaster or clay is allowed down sink. Wipe hands/tools with paper towels

thoroughly prior to washing hands/tools.

7. Absolutely no woodworking -or- metalworking tools are allowed for use with

plaster, including handtools, clamps, and especially powertools. Please do not

place plaster casts or buckets on the beds of powertools or table surfaces

designated as woodworking/metalworking surfaces.

Related Areas: Concrete areas/courtyard adjacent to Design

Spray painting is not allowed inside the shop area or in the general vicinity

(Sculpture and Design). If you are spray painting a project, you must do so outside,

and only on large sheets of butcher paper or cardboard. Do not spray paint any

project on bare concrete or grass in the courtyard.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

No comments

Delta (Model 31-300) User Manual Page 10