Delta SA350K Instruction Manual download pdf (Page 10)

FIG. 16

MACHINE USE

TROUBLESHOOTING

MAINTENANCE

SERVICE

FIG. 17

Sanding inside curves is illustrated in Fig. 16.

IMPORTANT: Always sand against the rotation of the

sanding drum.

The oscillating action of the sanding drum minimizes

score marks and prevents clogging of the sanding drum,

providing faster, smoother sanding and increasing

the life of the sanding sleeve.

For assistance with your machine, visit our website at www.DeltaMachinery.com for a list of service centers or call the

DELTA Machinery help line at 1-800-223-7278.

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp

cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.

Wear certiﬁed safety equipment for eye, hearing and respiratory protection while using compressed air.

After 100 hours of use, Change the grease in the gear

housing.

To gain access to the gear housing:

Disconnect the machine from the

power source!

1. T urn the machine over and loosen the two screws

(A Fig. 17 and remove the cover (B).

2. Remove the old grease and repack the gears

with new grease.

3. Replace the cover.

FAILURE TO START

Should your machine fail to start, check to make sure the prongs on the cord plug are making good contact in the

outlet. Also, check for blown fuses or open circuit breakers in the line.

LUBRICATION & RUST PROTECTION

Apply household oor paste wax to the machine table, extension table or other work surface weekly. Or use a commer-

cially available protective product designed for this purpose. Follow the manufacturer’s instructions for use and safety.

To clean cast iron tables of rust, you will need the following materials: a sheet of medium Scotch-Brite™ Blending

Hand Pad, a can of WD-40® and a can of degreaser. Apply the WD-40 and polish the table surface with the Scotch-

Brite pad. Degrease the table, then apply the protective product as described above.

REPLACEMENT PARTS

Use only identical replacement parts. For a parts list or to order parts, visit our website at www.DeltaMachinery.com/service.

You can also order parts from your nearest factory-owned branch, or by calling our Customer Care Center at 1-800-223-7278

to receive personalized support from highly-trained technicians.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

Delta SA350K Instruction Manual Page 10