Delta 36-714 User Manual download pdf (Page 16)

The saw table was aligned at the factory so that the miter gauge slots are parallel to the saw blade. However, check the

alignment before initial operation.

ALIGNING THE MITER SLOTS TO THE BLADE

Fig. 39

Fig. 40

Disconnect the machine from the power source.

ADJUSTING BLADE ALIGNMENT

Blade Alignment is factory-set and should not need adjustment. Aligning the blade in the field is a

difficult and time-consuming procedure. For assistance with your machine, visit our website at www.deltamachinery.com

for a list of service centers or call the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

1. Place a combination square (A) Fig. 39 on the table with one edge of the square in the miter gauge slot. Adjust the square

so that the ruler touches one of the teeth on the saw blade at the forward position (Fig. 39). Lock the square in this

position.

2. Rotate the saw blade so that the same tooth used in STEP 1 is in the rear position (Fig. 40)

3. To adjust, loosen the two hex head bolts (B) Fig. 15 that hold the rear trunnion to the saw table.

4. Use a rubber mallet (or a regular hammer and a block of wood) to tap the trunnion (C) until the saw blade is in the center

of the table insert slot, and parallel to the miter gauge slot.

5. Tighten the two hex head bolts that were loosened in STEP 3.

6. Tilt the blade to 45°. Turn the saw blade by hand to ensure that it does not contact the table insert. Check this distance. Both

the front and rear measure ments should be identical.

BACKLASH ADJUSTMENTS FOR BLADE-ADJUSTING MECHANISMS

If any play is detected in the blade-raising or blade-tilting mechanisms, do the following

1. Adjusting the elevation mechanism - Loosen the

locknut (A) Fig. 42 and turn the eccentric sleeve (B) until

all play is removed. Tighten the locknut.

2. Adjusting the tilting mechanism - Loosen the locknut

removed. Tighten the locknut.

Disconnect the machine from the power source.

Fig. 42

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 79 80

No comments

Delta 36-714 User Manual Page 16