Delta A Series Owner's Manual download pdf (Page 6)

Plug the other end of the power cable into an appropriate

power source.

Charging the Dog Collar Device

NOTICE

To prevent corrosion, thoroughly dry the contacts on the collar

and the surrounding area before connecting the charging clip.

Before you put the collar on the dog, remove the charging clip. If

you do not remove the clip, it may become detached from the

collar and become lost.

You should fully charge the battery before you use the device

for the first time. Charging a fully depleted battery takes about

two hours. The device will not charge when outside the

temperature range of 32° to 104°F (0° to 40°C).

Snap the charging clip

onto the device.

Plug the small end of the power cable into the mini-USB port

on the charging clip.

Plug the other end of the power cable into a power source.

The status LED is solid red when the collar is charging.

After the status LED turns solid green, remove the charging

clip from the collar.

Turning On the Devices

• On the handheld device, hold until the LCD display turns

on.

• On the dog collar device, hold until the status LED flashes

and the collar beeps twice.

Turning Off the Devices

• On the handheld device, hold until the LCD display turns

off.

• On the collar, hold until the status LED flashes and the

collar beeps once.

Dog Collar Devices

You can use up to three dog collar devices with a single

handheld device. You can select a different training mode and

intensity level for each dog collar device.

Each dog collar device must be paired with the handheld device

before it can be used. During the pairing process, each dog

collar device is associated with a color on the handheld device.

indicates the selected color.

Pairing a Dog Collar Device with the Handheld Device

NOTE: If your handheld device and dog collar device were

included in the same package, the devices are paired from the

factory using the black color selection.

Turn on the dog collar device and the handheld device.

On the handheld device, select to choose the color.

indicates the selected color.

On the handheld device, select an intensity level greater than

0 (page 3).

On the dog collar device, hold the power key for about two

seconds.

The device beeps once when you press the button and again

after two seconds.

After the second beep, on the handheld device, select a

training key.

The dog collar device turns off and beeps to indicate whether

the devices paired successfully.

Short beep Devices paired successfully

Long beep Devices did not pair

TIP: If the devices did not pair successfully, you should verify

the batteries in both devices are fully charged and the intensity

level is set higher than 0.

Selecting a Dog Collar Device

Before you can select and control a dog collar device, you must

pair the dog collar device with the handheld device (page 2).

Select to choose the color.

indicates the selected color.

The training keys control the dog collar device associated with

the selected color.

Dog Training

You should research and investigate the training methods best

suited for you, your dog, and your needs. This manual provides

some basic guidelines for training, but each dog has unique

training needs.

When used properly, the Delta training system is a very

effective training tool to aid your dog in reaching its full potential.

The use of the training system should be part of an overall

training program.

Begin training your dog on a leash, without the Delta training

system. You should train your dog how to heel, sit, and come to

you. After the dog understands these three basic commands,

you can begin training with the dog collar device and the leash.

Finally, when the dog consistently obeys commands using the

leash and collar, you may be able to remove the leash to train

with only the dog collar device.

Fitting the Collar on Your Dog

CAUTION

To prevent irritation from the contact points, remove the collar

for at least eight hours out of every 24-hour period.

This device is not intended for human use. Do not attempt to

use on any person.

NOTICE

Before you put the collar on the dog, remove the charging clip. If

you do not remove the clip, it may become detached from the

collar and become lost.

In order to properly correct the dog, the collar and device must

fit the dog properly. If the collar is too loose or positioned

incorrectly, corrections may be inconsistent. This can delay or

prevent successful training.

Place the collar around the middle of the dog's neck.

Position the device at the front of the dog's neck, with the

status LED facing toward the dog's chin and the contact

points against the throat.

2 Dog Training

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Delta A Series Owner's Manual Page 6

Comments to this Manuals

Related products and manuals for Recording Equipment Delta A Series