Delta 3544LF-WFMPU Installation Guide Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
E.
10
3
7
53916 Rev. D
D.
A.
Remove stopper (1), brass nut & washer
(2), black gasket (3) and tail piece (4).
B.
Applysiliconetoundersideofflange(5).Insert
flange into sink.
C.
Install black gasket (3), washer and brass nut (2) onto
flange (5) from below sink but do not tighten brass
nut (2). Screw on tail piece (4) and hand tighten.
D.
Withpivot(6)facingtowardfaucet,pull
pop-up straight down into drain hole and secure
gasket(3),brassnutandwasher(2).DONOT
TURNPOP-UPWHILETIGHTENINGBRASSNUT
ORSEALANTMAYNOTSEALDRAIN.Remove
excesssealant.
Pop-Ups with Metal Flange and Plastic Tail Piece
Renvoi mécanique avec collerette en métal et raccord droit de vidange en plastique
A.
Enlevezlabonde(1),l’écrouenlaitonetla
rondelle (2), le joint noir (3) et le raccord droit
de vidange (4).
B.
Appliquezdecomposéàlasiliconesousla
collerette (5). Introduisez la collerette
dans l’évier.
C.
Montez le joint noir (3), la rondelle et l’écrou en
laiton (2) sur la collerette (5) par dessous l’évier
sans serrer l’écrou en laiton (2).
Vissezle
raccord droit de vidange (4) et serrez-le à
la main.
C.
F.
E.
Remove pivot nut (7). Install horizontal rod (8) and
stopper (1) as removable (9) or non-removable (10).
Handtightenpivotnut(7).
F.
Attachhorizontalrod(8)tostrap(11)usingclip(8).
Installliftrod(12),tightenscrew(11).Connect
assembly to drain.
A.
Quiteeltapón(1),latuercadebronceyla
arandela (2), el empaque negro (3) y la pieza
de cola (4).
B.
Apliquesilicónpordebajodelabrida(5).
Introduzca la brida dentro del lavamanos.
C.
Instale el empaque negro (3), la arandela
y la tuerca de bronce (2) en la brida (5) desde
la parte interior del lavamanos pero no apriete
latuercadebronce(2).Atornillelapiezade
cola (4) y apriete a mano.
D.
Conelpivote(6)defrentealallave,haleel
desagüe automático directamente hacia abajo
dentro del drenaje y fije el empaque (3), la tuerca
debronceylaarandela(2).NOGIREEL
DRENAJEAUTOMÁTICOMIENTRASAPRIETELA
TUERCADEBRONCEOELSELLADORPUEDA
NOSELLARELDRENAJE.Quiteelexceso
de sellador.
Drenajes automáticos con brida de metal y la pieza de cola plástica
E.
Quitelatuercadelpivote(7).Instalelabarrahori-
zontal (8) y el tapón (1) como desmontable (9) o
fijo(10).Aprieteamanolatuercadelpivote(7).
F.
Una la barra horizontal (8) a la barra chata (11)
utilizando el gancho (8). Instale la barra de alzar
(12),aprieteeltornillo(11).Conecteelensamble
al desagüe.
D.
Alorsquelepivot(6)faitfaceaurobinet,tirezle
renvoi directement vers le bas dans l’orifice de
l’évier,puisfixezlejoint(3),l’écrouenlaitonetla
rondelle(2).NETOURNEZPASLERENVOI
PENDANTQUEVOUSSERREZL’ÉCROU EN
LAITONCARLECOMPOSÉ À LASILICONE
POURRANEPASASSURERL’ÉTANCHÉITÉ
DURENVOI.Enlevezl’excèsdecomposé
d’étanchéité.
E.
Enlevezl’écroudupivot(7).Installezlatige
horizontale (8) et la bonde (1) de manière que la
bonde soit amovible (9) ou non amovible (10).
Serrez l’écrou (7) du pivot à la main.
F.
Fixezlatigehorizontale(8)aufeuillard(11)à
l’aide de l’agrafe (8). Installez la tige de
manoeuvre(12)etserrezlavis(11).Fixez
l’ensemble au renvoi.
1
4
2
3
A.
SILICONE
B.
5
5
3
2
4
6
3
2
7
1
8
11
12
8
9
Page view 6
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments