Delta SHOPMASTER GR250 Instruction Manual download pdf (Page 8)

2. Align the holes in the eye shield with the holes in the

spark guard and place the eye shield spacer (A) Fig. 7, in

the space in the spark guard as shown.

3. Insert the eye shield bolt (A) Fig. 8, through the hole

in the eye shield (B), eye shield spacer (C), and spark

guard (D).

4. Place a 1/4" flat washer (E) Fig. 8, onto the end of the

eye shield bolt and fasten the eye shield knob (F) to the

end of the eye shield bolt.

5. Assemble the other eye shield in the same manner.

FASTENING GRINDER TO

SUPPORTING SURFACE

IF DURING OPERATION THERE IS ANY TENDENCY

FOR THE GRINDER TO TIP OVER, SLIDE OR

“WALK,” THE GRINDER MUST BE SECURED TO THE

SUPPORTING SURFACE USING FASTENERS (NOT

SUPPLIED) THROUGH THE TWO HOLES (A) Fig. 9, IN

THE GRINDER BASE.

Fig. 9

Fig. 7

Fig. 8

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND

STOPPING GRINDER

The switch (A) Fig. 10, is located on the front of the

grinder. To turn the grinder “ON” move the switch up to

the “ON” position. To turn the grinder “OFF” move the

switch down to the “OFF” position.

Fig. 10

LOCKING SWITCH IN

THE “OFF” POSITION

IMPORTANT: When the machine is not in use, the switch

should be locked in the “OFF” position to prevent

unauthorized use. This can be done by grasping the

switch toggle (A) and pulling it out of the switch, as

shown in Fig. 10. With the switch toggle (A) removed, the

switch will not operate. However, should the switch

toggle be removed while the sander is running, it can be

turned “OFF” once, but cannot be restarted without

inserting the switch toggle (A).

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Delta SHOPMASTER GR250 Instruction Manual Page 8