Delta 20-140 Instruction Manual

INSTRUCTION MANUALDATED 12-8-95 PART NO. 1349487©Delta International Machinery Corp. 199514" Abrasive Cut-Off Saw(Model 20-140)

10Fig. 18Fig. 19Fig. 20Fig. 21CARRYING HANDLEWhen transporting the machine, the cuttinghead shouldalways be locked in the down position by means of th

11Fig. 22Fig. 23Fig. 24Fig. 25Fig. 22 illustrates the cut-off piece after the cut is com-pleted. NOTE: The number of cuts per wheel, as well asthe qua

12Fig. 26Fig. 27BRUSH INSPECTIONAND REPLACEMENTCAUTION: BEFORE INSPECTING BRUSHES, DISCON-NECT THE MACHINE FROM THE POWER SOURCE.Brush life varies. It

13PARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufac-tured to high quality standards and are serviced bya network of

14

15

16Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machineaccessory which in normal use has proven

2TABLE OF CONTENTSSAFETY RULES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

3SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, there are certainhazards in

4ADDITIONAL SAFETY RULES FORABRASIVE CUT-OFF SAWS1. WARNING: Do not operate your abrasive cut-offsaw until it is completely assembled and installedacc

5UNPACKINGYour new 14 Abrasive Cut-Off Saw is shipped completein one carton. Carefully unpack the saw from the ship-ping container. Fig. 2 illustrates

6Fig. 5 Fig. 6CONNECTING SAW TO POWER SOURCEPOWER CONNECTIONSA separate electrical circuit should be used for your tools. This circuit should not be l

7OPERATING CONTROLS AND ADJUSTMENTSFig. 7Fig. 8INTERMEDIATE OPERATION – To turn the saw “ON”depress switch trigger (A) Fig. 7. To turn the saw “OFF”re

8Fig. 10Fig. 11Fig. 12Fig. 13VISEClamping the workpiece can be accomplished quicklyand easily as follows:1. Lift half-nut (A) Fig.10, off screw (B).2.

9Fig. 14Fig. 15Fig. 16Fig. 17ADJUSTINGDOWNWARD TRAVELOF ABRASIVE WHEELA stop screw (A) Fig. 14, is provided to limit the down-ward travel of the abras