Delta 20-140 Instruction Manual download pdf (Page 7)

OPERATING CONTROLS AND ADJUSTMENTS

Fig. 7

Fig. 8

INTERMEDIATE OPERATION – To turn the saw “ON”

depress switch trigger (A) Fig. 7. To turn the saw “OFF”

release switch trigger (A).

CONTINUOUS OPERATION – Depress switch trigger

(A) Fig. 8, and push in lock button (B). The saw will

remain “ON” until the switch trigger (A) is depressed.

LOCKING SWITCH IN

THE “OFF” POSITION

IMPORTANT: We suggest that when the machine is not

in use, the switch be locked in the “OFF” position using

a padlock (C) through the holes in the switch trigger (A),

as shown in Fig. 9.

TOTAL LENGTH OF GAGE OF EXTENSION

CORD IN FEET CORD TO USE

0 - 25 14 AWG

26 - 50 12 AWG

51 - 100 Not Recommended

101 - 150 Not Recommended

EXTENSION CORDS

Use proper extension cords. Make sure your extension

cord is in good condition and is a 3-wire extension cord

which has a 3-prong grounding type plug and a 3-hole

receptacle which will accept the tool’s plug When using

an extension cord, be sure to use one heavy enough to

carry the current of the saw. An undersized cord will

cause a drop in line voltage resulting in loss of power

and overheating. Fig. 6A shows the correct gage to use

de-pending on cord length. If in doubt, use the next

heavier gage. The smaller the gage number, the heavier

Fig. 6A

ON-OFF SWITCH

Your 14 Abrasive Cut-Off Saw is provided with an

ON-OFF switch that can be used for INTERMEDIATE

OPERATION or CONTINUOUS OPERATION, as follows:

Fig. 9

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Delta 20-140 Instruction Manual Page 7