Delta 36-412 Service Manual download pdf (Page 23)

--- 19 ---

(1) Setting to cut crown molding at positions and in Fig. 25 (See Fig. 26; tilt the head to the left.):

Turn the turn table to the right and set the miter angle as follows:

For 45˚ type crown moldings: 35.3˚ ( mark)

For 38˚ type crown moldings: 31.6˚ ( mark)

Turn the head to the left and set the bevel angle as follows:

For 45˚ type crown moldings: 30˚ ( mark)

For 38˚ type crown moldings: 33.9˚ ( mark)

Position the crown molding so that the lower surface ( in Fig. 24) contacts the fence as indicated in

Fig. 28.

3 A

Head

Miter angle scale

Bevel angle scale

Fig. 26

(2) Setting to cut crown moldings at positions and in Fig. 25 (See Fig. 27; tilt the head to the left.):

Turn the turn table to the left and set the miter angle as follows:

For 45˚ type crown moldings: 35.3˚ ( mark)

For 38˚ type crown moldings: 31.6˚ ( mark)

Tilt the head to the left and set the bevel angle as follows:

For 45˚ type crown moldings: 30˚ ( mark)

For 38˚ type crown moldings: 33.9˚ ( mark)

Position the crown molding so that the lower surface ( in Fig. 24) contacts the fence as indicated in

Fig. 29.

2 3

Fig. 27

Bevel angle scale

Turn table

Fence (A)

Miter angle scale

Fig. 28

Fig. 29

Fence

Table on base

Fence

Table on base

Base

Turn table

Base

Head

CAUTION: In the case of left bevel angle cutting, remove sub fence (C) before operation.

(Figs. 26 and 27)

Sub fence (C)

Fence (B)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Comments to this Manuals

No comments

Delta 36-412 Service Manual Page 23

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-412