Delta 36-412 Service Manual download pdf (Page 25)

--- 21 ---

Cutting method of crown molding without tilting the saw blade

6 mm wing bolt

Crown molding stopper (L)

(Optional accessory)

Crown molding

stopper (R)

(Optional

accessory)

6 mm

wing

bolt

Crown molding

vise ass'y

(Optional

accessory)

(1) Crown molding stoppers (L) and (R) (optional accessories) allow easier cuts of crown molding without tilting

the saw blade. Install them to both sides of the base as shown in Figs. 34-a and 34-b. After inserting, tighten

the 6 mm knob bolts to secure the crown molding guides.

[ Optional accessories used ]

Crown molding vise ass'y (including crown molding stopper (L))

Crown molding stopper (L)

Crown molding stopper (R)

(2) The crown molding vise ass'y (optional accessory) can be mounted on either the left fence (fence (B)) or the

right fence (fence (A)). It can unite with the slope of the crown molding and vise can be pressed down. Then

turn the upper knob, as necessary, to securely attach the crown molding in position. To raise or lower the vise

assembly, first loosen the 6 mm knob bolt.

After adjusting the height, firmly tighten the 6 mm wing bolt; then turn the upper knob, as necessary, to

securely attach the crown molding in position. (See Figs. 34-a and 34-b.)

WARNING: Always firmly clamp or vise to secure the crown molding to the fence; otherwise the

crown molding might be thrust from the table and cause bodily harm. Do not perform

bevel cutting. The main body or saw blade may contact the sub fence, resulting in an

injury.

CAUTION: Always confirm that the motor head does not contact the crown molding vise ass'y

when it is lowered for cutting. If there is any danger that it may do so, loosen the 6 mm

knob bolt and move the crown molding vise ass'y to a position where it will not contact

the saw blade.

Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING CONTACT

EDGE against crown molding stoppers as shown in Figs. 34-a and 34-b. Adjust the crown molding stoppers

according to the size of the crown molding. Tighten the 6 mm wing bolt to secure the crown molding stoppers.

Fig. 34-a Fig. 34-b

Crown molding vise ass'y

(Optional accessory)

Crown molding

6 mm wing bolt

Fence

6 mm knob bolt

Crown molding stopper (L)

Crown molding stopper (R)

(Optional accessories)

Knob

6 mm

wing

bolt

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 75 76

Comments to this Manuals

No comments

Delta 36-412 Service Manual Page 25

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-412