Delta 36-960 Instruction Manual download pdf (Page 11)

3. Fasten the leg bracket (L) Fig. 32, to the end piece (J)

of the t able using the two 1

/2″ flat head Phillip s screws, flat

washers and hex nuts (M) Figs. 31 and 32. Fasten the

remaining leg to the extension t able in the same manner.

ASSEMBLING EXTENSION TABLE

TO FRONT AND REAR RAILS

1. Place t able assembly (N) Fig. 34, in position between

the two rails, as shown. Make sure end of t able (N) is flush

against extension wing (P). Using a straight edge make

sure t able (N) is in the same plane and level with saw t able

(P). Lightly t ap table up or down and adjust leveling screws

(R) Fig. 33, in bottom of legs to accomplish this. When the

table (N) Fig. 34 is level and in the same plane with saw

table (P), drill

/4″ through holes (S) Fig. 34 through the

front and rear holes in the guide rail closest to the

extension wing. Fasten both front and rear rail to t able

using the 1

/2″ flat head Phillip s screws, flat washers, and

hex nut s. Using a level make sure t able (N) is in the same

plane and level with saw t able (P). Drill

/4″ through holes

(S) Fig. 34 through the front and rear holes remaining in

the guide rail.

2.Af ter the holes have been drilled in the edge of the

front and rear extension t able board, fasten both front and

rear rail to t able using the 1

/2″ flat head Phillip s screws, flat

washers, and hex nuts (M) Fig. 31.

ASSEMBLING GUIDE TUBE

TO FRONT RAIL

Lay the guide tube (B) on the saw t able as shown in Fig.

35, and line up the threaded holes on bottom of guide tube

(B) with the through holes (D) on the front rail (A). Fasten

the guide tube to the rail using

/2″ hex screws and

lockwashers in all of the holes.

REAR SUPPORT TABLE

MOUNTING INSTRUCTIONS

1. Position the two legs (H) Fig. 36, at the two far corners

of the inside of one end of the extension t able, as shown,

and mark the position of the eight holes to be drilled into

the bottom of the t able. Remove the two legs (H) and using

/16″ drill bit, drill the eight holes

/2″ deep. Replace the two

legs and fasten to the bottom of the t able using the eight

Fig. 32

Fig. 33

Fig. 34

Fig. 35

Fig. 36

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

Comments to this Manuals

No comments

Delta 36-960 Instruction Manual Page 11

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-960