Delta 36-960 Instruction Manual download pdf (Page 17)

SCREWS (D) AND (E) IS NECESSARY TO ADJUST THE FENCE PARALLEL WITH THE MITER GAGE SLOT.

ADJUSTING CLAMPING ACTION

OF FENCE LOCKING HANDLE

When the fence locking handle (A) is pushed to the down

position, as shown in Fig. 61, the fence assembly (B)

should be completely clamped to the guide tube (C). If the

fence assembly (B) is not completely clamped to the guide

tube (C) when the handle (A) is pushed down, as shown

in Fig. 61, lif t up handle (A) and raise fence assembly (B)

up of f the guide tube (C). Slightly tighten the two adjusting

screws (D) and (E) Fig. 60, using the

/16″ allen wrench (F)

(not supplied). When a djusting screws (D) and (E) Fig.

60. the screws should be tightened to an equal amount .

Place fence on guide tube and recheck, adjust if

necessarry.

IMPORTANT: AFTER ADJUSTING THE

CLAMPING ACTION OF THE FENCE LOCKING

HANDLE, CHECK TO SEE IF THE FENCE IS

PARALLEL TO THE MITER GAGE SLOT A N D

ADJUST IF NECESSARY.

ADJUSTING TABLE INSERT

Place a straight edge (B) across the t able at both ends of

the t able insert as shown in Fig. 62. The t able insert (A)

should always be level with the t able. If an adjustment is

necessary, turn the adjusting screws (C), as needed. Four

adjusting screws (C) are supplied.

CONNECTING SAW TO POWER SOURCE

GROUNDING INSTRUCTIONS

CAUTION: THIS TO O L MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM

ELECTRIC SHOCK.

In the event of a malfunction or breakdown, grounding

provides a p ath of least resist ance for electric current to

reduce the risk of electric shock. The motor is equipped

with an electric cord having an equipment-grounding

conductor and a grounding plug. The plug must be

plugged into a matching outlet that is properly inst alled

and grounded in accordance with all local codes and

ordinances.

Do not modify the plug provided - if it will not fit the outlet,

have the proper outlet inst alled by a qualified electrician.

Improper connection of the equipment-grounding

conductor can result in risk of electric shock. The con-

ductor with insulation having an outer surface that is green

with or without yellow stripes is the equipment-grounding

conductor. If rep air or replacement of the electric cord or

plug is necessary, do not connect the equipment

grounding conductor to a live terminal.

Fig. 61

Fig. 62

Fig. 63

CURRENT CARRYING

PRONGS

GROUNDING

PRONG

240

VOLT

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

Comments to this Manuals

No comments

Delta 36-960 Instruction Manual Page 17

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-960