Delta 36-960 Instruction Manual download pdf (Page 9)

10. Assemble splitter (P) Fig. 22, inside the splitter

mounting bracket as shown. Push splitter (P) down as far

as possible, making cert ain bottom edge (T) of splitter (P)

is p arallel with t able surface, and tighten screw (B).

11. Reassemble the saw blade (U) Fig. 22.

12. Using a straight edge (A) Fig. 23, and square (B) Fig.

24, align splitter (P) with the saw blade and t able by

moving brackets (M) and (L) until the splitter (P) is in

perfect alignment with the blade and square with the

table. After alignment is made, tighten hex head screw

(N), and two screws (S) Fig. 24.

13. IMPORTANT: For cert ain cutting operations such as

dadoing and moulding where you are not cutting

completely through the workpiece, the blade guard and

splitter assembly cannot be used. Loosen screws (B) and

(V) Fig. 25. Lif t up and swing blade guard and splitter

assembly to the rear of the saw. CAUTION: Always return

the blade guard and splitter assembly to it s proper

operating position for normal thru-sawing operations.

BIESMEYER FENCE

ASSEMBLY

ASSEMBLING GUIDE RAILS

1. Assemble the front rail (A) Fig. 26, to front of saw

table using the two

/8-16 x 1

/4″ flat head Phillip s screws

(B),

/8″ flat washers, lockwashers and

/8-16 hex nut s

supplied. Screws (B) are inserted through the two holes in

the front rail, as shown in Fig. 26, and through the two

through holes in the front of the saw t able and fastened to

the t able with the flat washers, lockwashers and hex nut s.

IMPORTANT: Do not completely tighten front rail

mounting hardware at this time.

Fig. 22

Fig. 23

Fig. 24

Fig. 25

Fig. 26

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

No comments

Delta 36-960 Instruction Manual Page 9