Delta 36-978 Instruction Manual download pdf (Page 16)

3. Slide the belt and pulley guard bracket (I) Fig. 36,

between the motor plate (J) and motor mounting

plate (K), as shown.

5. Position belt and pulley guard bracket (I) Fig. 37, so

the motor pulley (K) is centered and through the hole

in the belt and pulley guard bracket (I), as shown in

Fig. 37. Tighten the four hex nuts (C) Fig. 31 that

fasten the motor to the motor mounting plate.

6. Using a straight edge, align the motor pulley with the

arbor pulley in the saw cabinet. If necessary, adjust

the motor pulley (K) Fig. 37, in or out on the motor

shaft.

7. Lift up on the motor and assemble the drive belt

(L) Fig. 38, to the arbor pulley and motor pulley (K)

Fig 38. The weight of the motor will provide the

correct belt tension.

4. Place a ¼" External Tooth Lockwasher onto a ¼-20

x 1 ½" Hex Head Screw. Insert the screw (L) Fig. 36,

through the hole in the belt and pulley guard bracket

(I) as shown in Fig. 36.

Fig. 36

Fig. 37

Fig. 38

8. IMMEDIATELY AFTER ASSEMBLING

THE BELT, RAISE THE SAW BLADE

TO ITS MAXIMUM HEIGHT AND TILT THE SAW BLADE

TO 45 DEGREES. USING A STRAIGHT EDGE (M) FIG.

39, CHECK TO SEE IF THE MOTOR END (N) FIG. 39,

IS BELOW THE TOP OF THE TABLE SURFACE (O). IF

THE MOTOR END IS ABOVE THE TOP OF THE TABLE

SURFACE, LOOSEN THE FOUR HEX NUTS (F) FIG. 31,

RE-POSITION MOTOR AND THEN RETIGHTEN THE

NUTS. THEN, RE-ALIGN THE MOTOR PULLEY (K) FIG. 38

TO THE ARBOR PULLEY.

Fig. 39

Downloaded from www.Manualslib.com manuals search engine

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 36 37

No comments

Delta 36-978 Instruction Manual Page 16