Delta BS150LS Instruction Manual download pdf (Page 15)

ADJUSTING LOWER BLADE GUIDES

AND BLADE SUPPORT BEARING

Disconnect machine from power

source.

The lower blade guides and blade support bearing

should be adjusted at the same time as the upper guides

and support bearings as follows:

1. Loosen two screws (A) Fig. 29, and move guides

(B) as close as possible to the sides of the blade.

Be careful not to pinch the blade. Tighten the two

screws (A). NOTE: In Fig. 29, the table has been

removed for clarity.

2. The front edge of the blade guides (B) Fig. 29 should

be adjusted so they are just behind the "gullets" of

the blade teeth. Loosen screw (C), and move the

assembly (D) in or out as necessary. Tighten screw

(C).

3. The lower blade support thrust bearing (E) Fig.

29 prevents the saw blade from being pushed

back too far during cutting. The support bearing

should be adjusted approximately 1/32" behind

the blade. Loosen screw (F) Fig. 29, and move the

bearing shaft (G) in or out as necessary. Tighten

screw (F).

4. The lower blade support bearing (E) Fig. 29 should

also be adjusted so that the blade overlaps the

outside diameter of the ball bearing by approximately

1/8". The blade support bearing (E) is set on an

eccentric shaft.To change the position of the bearing

(E), loosen the screw (F) Fig. 29 and rotate the shaft

(G) Fig 30 until the blade properly overlaps the

support bearing. Tighten screw (F) Fig. 29.

Fig. 29

Fig. 30

Fig. 31

TILTING THE TABLE

The table can be tilted 45 degrees to the right. To tilt the

table, loosen lock handle (A) Fig. 31 and turn knob (B)

clockwise until desired angle is established. Then tighten

lock handle (A). NOTE: The table lock handle (A) can be

repositioned by pulling out on the handle and reposition-

ing it on the nut located underneath the hub of the han-

dle. A scale (C) and pointer (D) are provided to indicate

the degree of tilt.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 71 72

Comments to this Manuals

No comments

Delta BS150LS Instruction Manual Page 15

Comments to this Manuals

Related products and manuals for Circular saws Delta BS150LS