Delta BS150LS Instruction Manual download pdf (Page 16)

ADJUSTING THE TABLE

POSITIVE STOPS

Positive stops are provided for the table at the 90 and

45 degree angle to the blade. To check and adjust the

positive stops:

Disconnect machine from power

source.

1. Tilt the table to the 90 degree position as shown in

Fig. 32 and tighten lock handle (A). Place a square

(H) on the table and against the blade and check to

see if the blade is 90 degrees to the table surface. If

an adjustment is necessary:

2. Tilt the table to expose the lock nut (E) Fig. 33.

Loosen lock nut (E) and return table to the 90°

position. With the lock handle (A) Fig. 32 loose, turn

the adjusting screw (F) Fig. 34, using the 3mm hex

wrench provided until the blade is 90 degrees to the

table. Then tighten lock handle (A) and lock nut (E) on

the adjustment screw (F).

3. Tilt the table to the 45 degree position as shown

in Fig. 34. Place a square (H) Fig. 34 on the table

and against the blade and check to see if the blade

is 45 degrees to the table surface. If an adjustment

is necessary.

4. Loosen the lock nut (N) Fig. 33 on the adjustment

screw (J) located on the underside of the table. With

the lock handle (A) Fig. 34 loose, turn adjustment

screw (J) using 3mm hex wrench provided until

the blade is 45 degrees to the table. Tighten lock

handle (A) and lock nut (N) on the adjustment screw

(J).

Fig. 33

Fig. 32

Fig. 34

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 71 72

No comments

Delta BS150LS Instruction Manual Page 16