Delta MS210 Instruction Manual download pdf (Page 9)

Fig. 12

Fig. 13

ROTATING TABLE FOR MITER CUTTING

Your miter saw will cut any angle from a straight 90 degree cut to 47 degrees, right and left. Loosen lock handle

(A) Fig. 12 one or two turns, depress index lever (B) and move the control arm to the desired angle. TIGHTEN LOCK

HANDLE (A).

The miter saw is equipped with positive stops at the 0, 22-1/2, and 45 degree, right and left positions. Loosen lock

handle (A) Fig. 12, and move the control arm until the bottom of the index lever (B) engages into one of the positive

stops, four of which are shown at (C). TIGHTEN LOCK HANDLE (A). To disengage the positive stop, depress index

lever (B).

IMPORTANT: Always tighten the lock handle (A) Fig. 12 before cutting.

POINTER AND SCALE

A pointer (A) Fig. 13 is supplied which indicates the actual angle of cut. Each line on the scale (B) represents 1 degree.

When the pointer is moved from one line to the next on the scale, the angle of cut is changed by 1 degree.

STARTING AND STOPPING MACHINE

To start the machine, depress switch trigger (A) Fig. 10. To stop the machine, release the switch trigger. This miter saw

is equipped with an automatic electric blade brake. As soon as the switch trigger (A) Fig. 10 is released, the electric

brake is activated and stops the blade in seconds.

Fig. 10

A turning saw blade can be hazardous. After completing the cut, release the switch trigger (A)

Fig. 10 to activate the blade brake. Keep the cutterhead down until the blade has come to a

complete stop.

The torque developed during braking may loosen the arbor screw. The arbor screw should be

checked periodically and tightened if necessary.

Fig. 11

LOCKING SWITCH IN THE “OFF” POSITION

IMPORTANT: When the machine is not in use, the switch should be locked in the “OFF” position to prevent

unauthorized use, using a padlock (B) Fig. 11 with 3/16" diameter shackle.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

No comments

Delta MS210 Instruction Manual Page 9