Delta MS265 Instruction Manual download pdf (Page 19)

MAINTENANCE

CHANGING THE BLADE

Use only cross-cutting saw blades.

When using carbide-tipped blades, do not use blades with deep gullets as they can deflect and

contact the guard.

Use only 10" diameter saw blades rated for 5200 rpm or higher, and have 5/8" diameter arbor holes.

Disconnect machine from power source.

The no-load speed of this machine is 5200 rpm.

REMOVE WRENCHES (A) FIG. 44 AND (A) FIG. 45 BEFORE STARTING THE MACHINE.

1. Remove the screw (A) Fig. 42 and rotate the cover (B) Fig. 43 to the rear.

2. To remove the saw blade, insert the hex wrench (A) Fig. 42 into the hex hole located on the rear end of the motor

shaft to keep the shaft from turning.

3. Use a wrench (A) Fig. 44 to loosen the arbor screw (C) by turning it clockwise.

4. Remove the arbor screw (C) Fig. 45, outside blade flange (B), and saw blade from the saw arbor.

5. Attach the new saw blade making certain that the teeth of the saw blade are pointing down at the front. Attach

the outside blade flange (B) Fig. 45, then the arbor screw (C), and turn it counterclockwise, using the wrench (A)

Fig. 45. At the same time, use the hex wrench (A) Fig. 42 to keep the arbor from turning.

6. Rotate the cover back to its original position and secure it in place with the screw removed in STEP 1.

Fig. 42

Fig. 43

Fig. 44

Fig. 45

NOTE:

TROUBLESHOOTING

For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call

the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

1 2 ... 14 15 16 17 18 19 20 21 22 23

No comments

Delta MS265 Instruction Manual Page 19