Delta MS265 Instruction Manual download pdf (Page 9)

Thread the table lock handle (A) Fig. 5 into the threaded hole of the arm bracket (C).

ROTATING TABLE

Loosen the table-lock handle one or two turns. Raise

the index lever (B) Fig. 5 and rotate the table to the

desired position. Tighten the table-lock handle.

MOVING CUTTINGHEAD TO THE UP POSITION

ATTACHING DUST BAG

Attach the dust bag (A) Fig. 7 to the dust spout (B) making sure the wire ring (C) is engaged with the ridge in the spout

(see inset).

Fig. 5

Fig. 6

Fig. 7

FASTENING MACHINE TO SUPPORTING SURFACE

Before operating your compound miter saw, mount it to

a sturdy workbench or other supporting surface. Four

holes are provided, two of which are shown at (A) Fig. 8.

When frequently moving the saw from place to place,

mount the saw to a 3/4″ piece of plywood. The tool can

then be easily moved from place to place and the

plywood can be clamped to a supporting surface using

“C” clamps.

Fig. 8

1. Push down on cuttinghead and pull out cuttinghead lock knob (A) Fig. 6.

2. Move the cuttinghead to the up position.

ATTACHING TABLE LOCK HANDLE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

No comments

Delta MS265 Instruction Manual Page 9