Delta RS830 Instruction Manual download pdf (Page 16)

6. When both right and left edges of the table board

are the same distance from the table supports, tighten

four screws located in holes (N) Fig. 21, of front table

board (A).

Fig. 21

7. Insert four 1/4-20x1-1/4" round head screws (P) Fig.

22, into holes (R) Figs. 21 and 22, of the table board as

shown, and tighten each of the screws until each corner

of the table board raises approximately 1/8".

Fig. 22

8. Loosen bevel clamp lever (S) Fig. 23, pull out bevel

index knob (T), and rotate motor (V) to the vertical

position as shown, until bevel index engages. Then

tighten bevel clamp lever (S). NOTE: If the motor shaft

contacts the table board before the motor is fully

rotated, raise the track arm (X) Fig. 24, by turning

elevating handle (C).

Fig. 23

9. Loosen cutting-head clamp knob (W) Fig. 23, and

move cutting-head to the front of track arm (X). Then

tighten cutting-head clamp knob (W).

Fig. 24

10. Loosen track arm clamp handle (Y) Fig. 24. NOTE:

Track clamp handle (Y) Fig. 24, has left handed threads.

Press down on indexing release handle (Z) Fig. 24, and

pivot track arm (X) Fig. 24, to the left until motor shaft (B)

Fig. 25, is near front left adjustment screw (P) Fig. 25, of

table board (A) Fig. 25, as shown. Then tighten track arm

clamp handle (Y) Fig. 24.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

No comments

Delta RS830 Instruction Manual Page 16