Delta RS830 Instruction Manual download pdf (Page 18)

TABLE BOARD CLAMPS AND TABLE

BOARDS

1. Locate table board clamps (A) Fig. 29, and insert

one clamp into each of the slotted holes (B) located at

the rear of each table support bracket (C) as shown in

Fig. 30.

Fig. 29

Fig. 30

Fig. 31

Fig. 32

2. Turn adjusting screw (D) Fig. 30 counter clockwise,

so that the knobs (A) are in the rear position as shown.

3. Place 1-1/4" wide board (E) Fig. 31, against front

table board (G), and 5-3/4" wide board (J) against 1-1/4"

wide board (E), place the 1-3/4" wide board (H) in the

upright position against the 5-3/4" wide board (J) as

shown. Then tighten knobs (D), until the table boards are

securely clamped in position.

ADJUSTING AND CHECKING SAW

BLADE TRAVEL SQUARE TO FENCE

1. DISCONNECT MACHINE FROM POWER

SOURCE.

2. Raise track arm (A) Fig. 32, by turning elevating

handle (B) until the blade (C) can be assembled on the

motor shaft. Then tighten arbor nut (D) using the

wrenches supplied.

3. Place a framing square (E) Fig. 32, against fence (H)

as shown, and lower track arm (A) until the blade just

clears the table surface.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

No comments

Delta RS830 Instruction Manual Page 18