Delta RS830 Instruction Manual download pdf (Page 23)

CUTTING INTO TABLE BOARDS

1. Assemble table boards (A) Fig. 48, and fence (B) as

shown and secure in place with table clamps, one of

which is shown at (C).

Fig. 48

Fig. 49

Fig. 50

Fig. 51

2. Return cutting-head (D) Fig. 49, to rear of track arm

(E), and tighten cutting-head clamp knob (G) Fig. 48.

Make sure switch (H) Fig. 49, is in the “OFF” position

and connect saw to power source.

3. While holding cutting-head handle (L) Fig. 49 firmly,

turn switch (H) “ON” and lower track arm (E) by turning

elevating handle (K) as shown. Lower saw blade until it

cuts into the table surface approximately 1/16” deep.

Then stop turning elevating handle (K).

4. While still holding cutting-head handle (L) Fig. 50

firmly, loosen cutting-head clamp knob (G) Fig. 48, and

slowly pull cutting-head (D) Fig. 50, toward the front of

the track arm (E) as shown, until travel stops. Then turn

switch (H) “OFF”.

5. Once saw blade (M) Fig. 51, has come to a complete

stop, return cutting-head (D) to rear of track arm (E) as

shown. Fig. 51, illustrates saw kerf (N) cut into table boards.

IMPORTANT: THE TRACK ARM (E) FIG. 51, MUST BE

RAISED BEFORE ATTEMPTING TO ROTATE IT. ALSO,

THE PROCEDURE “CUTTING INTO TABLE BOARDS”

MUST BE PERFORMED FOR EACH ANGLE CUT

DESIRED.

FASTENING SAW TO THE FLOOR

If during operation there is any tendency for the saw to

tip over, slide, or walk on the supporting surface, the

saw should be secured to the floor surface through

holes provided on the bottom of each leg.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 32 33

No comments

Delta RS830 Instruction Manual Page 23