Delta 14-651 Instruction Manual download pdf (Page 11)

NOTE: Reverse the procedure to remove the column extension.

Fig. 20

OPERATING CONTROLS AND ADJUSTMENTS

The power switch is located on the left side of the mortiser.

To turn the mortiser “ON”, press the green start button (A)

Fig. 21. To stop the mortiser, push the red button (B).

When the tool is not in use, the switch should be locked in the

“OFF” position to prevent unauthorized use. Insert the

lockout pin (C) Fig. 22 (Delta accessory model number 50-

164) through the hole in the start button (A). Place the 1/8"

shank of a lock through the hole in the lockout pin and secure.

STARTING AND STOPPING MORTISER

LOCKING SWITCH IN THE “OFF” POSITION

A depth stop rod (A) Fig. 23 is provided to limit the depth of

the chisel. To adjust the depth stop rod (A), loosen the lever

Lower the depth stop rod (A) until it contacts the top of the

column (D) and tighten the lever (C).

DEPTH STOP ROD

The fence (A) Fig. 24can be moved in or out by loosening the

lock handles (B), and rotating the fence rack handle (C). Move

the fence to the desired position and tighten the handles (B).

NOTE: Levers (B) are spring-loaded and can be repositioned

by pulling out on the lever and repositioning it on the serrated

nut located underneath the lever.

FENCE

Fig. 21

Fig. 22

Fig. 23

Fig. 24

To prevent damage to the unit, place the rack

cover over the gear. This action will prevent

the cover from being trapped between the

rack and the gear.

1 2 ... 6 7 8 9 10 11 12 13 14 15

No comments

Delta 14-651 Instruction Manual Page 11