Delta 14-651 Instruction Manual download pdf (Page 8)

TOOL AND CHISEL HOLDER

1. Attach the tool and chisel holder (A) Fig. 7 to the back of the column, using the two M6x1x25mm screws (B) and

M6 lockwashers.

2. Fig. 8 illustrates the stored chuck key/wrench (C), bushing (F) for use with extra long chisels, and chisels and bits (E).

For your own safety, do not connect the machine to the power source until the machine is completely

assembled and you read and understand the entire instruction manual.

RAISING AND LOWERING HANDLE

1. Attach the hub of the handle assembly (A) Fig. 3 to the end of the pinion shaft (B) and fasten the handle to the

pinion shaft using the special screw (C) and spring (D).

2. Raise the mortising machine head (E) Fig. 4 to the "up" position by turning the handle (A) clockwise.

NOTE: The handle (A) is spring-loaded. Reposition it by pulling it out and moving it on pinion shaft (B).

HYDRAULIC CYLINDER

Make sure that the head (A) Fig. 5 is held in the “up” position. Attach the hydraulic cylinder (B) to the two fittings, one

located on the back of the head (C) Fig. 5, and the other on the column (D) Fig. 6. Push each end of the hydraulic

cylinder on its fitting to secure the cylinder.

ASSEMBLY

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Fig. 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Delta 14-651 Instruction Manual Page 8