Delta 32-325 Instruction Manual download pdf (Page 11)

4. With the index pins (B) Fig. 13 engaged in the gauge holes (A), loosen the table lock knobs, one of which is shown

at (E). Move the table until the front of the fence (F) is approximately 1/32" away from the gauge at point (G) on

each end of the gauge. Tighten the table lock knobs (E).

5. Use a small “C” clamp (not supplied) to secure the table bracket (K) Fig. 18 to the machine frame (L) at a point

between the two slides to avoid movement. Clamp the table bracket on the other side of the machine to the

machine frame in the same manner.

6. Loosen the two screws (E) Fig. 10 that fasten the fence (F) Fig. 14 to the machine. Move the fence (F) until the

front surface of the fence contacts the gauge at point (G) on each end of the gauge. Move the fence left or right

until the right fence stop (set in STEP 1 - see inset - Fig. 14) contacts the gauge at point (H) Fig. 14. Tighten the

fence mounting hardware.

NOTE: The fence stop was removed for clarity.

7. Refer to the following instructions “ADJUSTING THE TABLE PARALLEL TO THE FENCE.”

1. Remove the gauge (A) Fig. 13. The points of the index pins (B) Fig. 15 should point to the 2-1/4" mark on both

scales.

2. If an adjustment is necessary, loosen the four screws (C) Fig. 15 that fasten the table to the machine frame. Adjust

the table until the index pins (B) point to the 2-1/4" mark on scales (A). IMPORTANT: Make sure that the table

mounting brackets are held securely against the machine frame and tighten four screws (C).

3. Replace the knobs (D) Fig. 16 on top of the indexing pins (B).

NOTE: The space between the rear of the table and the front of the fence is for chip removal.

4. Remove two clamps temporarily attached in STEP 5

of section “ALIGNING THE FENCE PARALLEL TO THE LINE-

BORING HEAD.”

ADJUSTING THE TABLE PARALLEL TO THE FENCE

Fig. 13

Fig. 14

Fig. 15

Fig. 16

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Delta 32-325 Instruction Manual Page 11