Delta 36-600 Instruction Manual download pdf (Page 14)

Fig. 22

Fig. 23

Fig. 24

Fig. 25

LEVELING AND ADJUSTING

FRONT GUIDE RAIL

1. MAKE CERTAIN THE TOOL IS DISCONNECTED

FROM THE POWER SOURCE. Raise saw blade to its

highest level.

2. With handle (A) Fig. 22 in the raised position, place

rip fence (B) on the saw table as shown. NOTE: Make

certain rip fence (B) is engaged on rear guide rail (C).

Move rip fence (B) against saw blade as shown in Fig. 23.

3. Carefully move front guide rail (D) Fig. 23, left or right

as needed until line on cursor (E) aligns with zero (“0”) on

guide rail scale (F). Push handle (A) downward to lock rip

fence in position. Snug up front guide rail mounting

hardware. Minor adjustment to the cursor (E) Fig. 24 can

be made by loosening two screws (G), adjusting cursor

left or right, and tightening two screws (G). Remove rip

fence and lower saw blade.

4. Using a square (H) Fig. 25 set at 13/16″, place the

square on the saw table and against the top of guide rail

(D). Align the guide rail until it is parallel to the saw table

by loosening and tightening mounting hardware at five

positions (K) Fig. 25.

5. Check the guide rail adjustment again to make certain

the rip fence is aligned with the guide rail scale.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 28 29

No comments

Delta 36-600 Instruction Manual Page 14