Delta 37-285 Owner's Manual download pdf (Page 10)

ASSEMBLING

CUTTERHEAD GUARD

MAKECERTAIN THE MACHINE IS DISCONNECTED

FROM THE POWER SOURCE AND THAT KNIFE

GUARDIS POSITIONED OVER THE CUTTERHEAD.

1. Remove set screw (A) Fig. 17, from the post of the

cutterhead guard (B) with supplied wrench (C).

Fig. 16

Fig. 17

Fig. 18

Fig. 19

5. Assemble the free end of spring (M) Fig. 16, onto the

rear edge of bracket (F). NOTE: The tension on spring

(M) Fig. 16, automatically allows safety guard (N) to move

forward with the fence (K) and over the rear of the cutter-

head for operator safety.

6. IMPORTANT:REMOVE KNIFE GUARD FROM

CUTTERHEAD ASSEMBLY.

2. Insert the post of cutterhead guard (B) Fig. 18, down

through hole (D) in the infeed t able. NOTE: A spring is

supplied inside knob assembly (E) Fig. 18, that returns

guard (B) over the cutterhead af ter the cut has been

made. Turn knob (E) Fig. 18, to provide tension on the

spring before inserting the post. Make certain the

spring inside knob (E) engages slot in cutterhead

post and that the guard (B) is positioned over pin (F) .

If spring tension is too much or too little, adjust the

tension spring accordingly by removing the guard and

rot ating knob (E).

3. Thread set screw (A) Fig. 19, which was removed in

STEP 1, back into post to keep cutterhead guard (B) in

position during jointer operation.

4. Fig. 19, illustrates the cutterhead guard (B) assem -

bled to the infeed t able. NOTE: When inst alled correctly ,

the guard should spring back over the cutterhead af ter

the cut.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

No comments

Delta 37-285 Owner's Manual Page 10