Delta 37-285 Owner's Manual download pdf (Page 9)

Fig. 12

Fig. 13

Fig. 15

Fig. 14

ASSEMBLING M O TO R

PULLEY GUARD

MAKECERTAIN THE MACHINE IS DISCONNECTED

FROM THE POWER SOURCE AND THAT KNIFE

GUARD(A) FIG. 13, IS POSITIONED OVER THECUT-

TERHEAD.

1. Assemble motor pulley guard (C) Fig. 12, so it fits

a round the out side of the belt and pulley guard (B). Fasten

the motor pulley guard (C) Fig. 12, to the side of the st a n d

with #8-32 x 1/4 round head screw (D), two flat wash -

ers, and hex nut.

ASSEMBLING FENCE

ASSEMBLY TO JOINTER

MAKECERTAIN THE MACHINE IS DISCONNECTED

FROM THE POWER SOURCE AND THAT KNIFE

GUARD(A) FIG. 13, IS POSITIONED OVER THECUT-

TERHEAD.

1. Position fence slide bracket (B) Fig. 13, over the two

threaded holes (C) at the rear of the jointer and fasten

the support bracket with two cap screws (D) and supplied

wrench (E).

2. Place fence support bracket (F) Fig. 14, over rod in

slide bracket assembly (B) and fasten with flat washer

and locking lever (G).

3. Fig. 15, illustrates the slide and support bracket s

assembled to the jointer.

4. Align the two holes in the fence support bracket (H)

Fig. 15, with two holes (J) in fence (K) and carefully

fasten the fence to the fence support bracket with two flat

washers and 1/4-20 x 3/4 square head screws (L) as

shown in Fig. 16.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

No comments

Delta 37-285 Owner's Manual Page 9