Delta 37-285 Owner's Manual download pdf (Page 8)

ASSEMBLING STAND A ND

DUST CHUTE TO JOINTER

MAKECERTAIN THE MACHINE IS DISCONNECTED

FROM THE POWER SOURCE AND THAT KNIFE

GUARD(A) FIG. 13, IS POSITIONED OVER THECUT-

TERHEAD.

1. Carefully turn the jointer (A) Fig. 7, up side-down so

the t able is resting on a supporting surface similar to the

two pieces of 4 x 4 lumber as shown. This will facili-

tate the assembly of the dust chute (B) Fig. 8, and st a n d

2. Align the three mounting holes (D) Fig. 8, in the st a n d

with three mounting holes in the base of the jointer as

shown in Fig. 8.

ASSEMBLING BELT

AND PULLEY GUARD

MAKECERTAIN THE MACHINE IS DISCONNECTED

FROM THE POWER SOURCE AND THAT KNIFE

GUARD(A) FIG. 13, IS POSITIONED OVER THECUT-

TERHEAD.

1. Loosely thread two 1-1/4-20 x 1/2 truss head

screws (A) Fig. 10, into the two t apped holes at the rear

of the jointer t able.

2. Insert slot s in guard (B) under heads of screws (A)

as shown in Fig. 1 1, and tighten screws to hold guard in

position.

Fig. 7

Fig. 8

Fig. 10Fig. 9

Fig. 1 1

3. Position dust chute (B) Fig. 9, as shown, over two of

the holes (D) that were aligned in STEP 2.

4. Assemble the dust chute (B) and st and (C) Fig. 9, at

each hole (D) with a 5/16-18 x 1-1/4 long hex head

screw (E), two flat washers (F), and hex nut (G). NOTE:

Screws are to be inst alled upward from the base of the

jointer .

5. Carefully turn the jointer with st and and dust chute

att ached so the jointer is resting on the st and. IMPOR-

TA N T: W e strongly suggest that two people perform this

operation.

6. Apply downward pressure on the jointer so the legs

of the st and are adjusted to the floor surface and tighten

all stand mounting hardware.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 22 23

Comments to this Manuals

No comments

Delta 37-285 Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Delta 37-285