Delta 43-355 Instruction Manual download pdf (Page 12)

Fig. 28 Fig. 29

Fig. 30

Fig. 31

Fig. 33

Fig. 32

CHANGING SPINDLES

AND REPLACING BELTS

CHANGING SPINDLES

The spindle assembly in your shaper is equipped with a

1/2 inch diameter spindle on one end and 3/4 inch

diameter spindle on the other end. To change from one

diameter to the other, proceed as follows:

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Lower the front panel of the shaper.

3. Loosen belt tension knob (A) Fig. 28, and remove

belt from motor pulley (B).

4. Remove two nuts (C) Fig. 28.

5. Remove spindle assembly (D) Fig. 29, and turn

spindle assembly end for end.

REPLACING BELTS

6. PIace belt (J) Fig. 30, around spindle shaft (K) and

through opening (L) in elevating bracket, as shown.

Assemble spindle assembly to elevating bracket by

inserting two screws (M) into two holes (N) Fig. 31 and

fasten in place using two one-piece nuts and star

washers (O) Fig. 31.

7. Fig. 32, illustrates the spindle and belt assembled to

the elevating bracket.

8. PIace belt (J) Figs. 32 and 33, on one of the steps of

the motor pulley (R). It may be necessary to loosen belt

tension knob (S) Fig. 32, in order to allow the belt to fit

around the motor pulley (R) Figs. 32 and 33. Align belt (J)

on spindle shaft (K) with the motor pulley and tighten

belt tension knob (S) Fig. 32.

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Delta 43-355 Instruction Manual Page 12