Delta 43-355 Instruction Manual download pdf (Page 6)

UNPACKING

The shaper is shipped with the motor assembly, spindle

and belt assembled to the underside of the table.

Place the shaper table and motor assembly upside

down on a suitable surface, such as two saw horses,

making certain there is clearance for the spindle (A).

IMPORTANT: The spindle assembly is double-sided,

with a 1/2 inch diameter spindle on one end and a 3/4

inch diameter spindle on the other end. The shaper ¡s

shipped with the 1/2 inch diameter spindle in the

operating position. if you desire to use the 3/4 inch

diameter spindle, refer to section "CHANGING

SPINDLES AND REPLACING BELTS."

Fig. 2

ASSEMBLY INSTRUCTIONS

ASSEMBLING STAND

1. Assemble the four legs (E) Fig. 3, to bottom of table.

Align the hole in the bottom of the leg with the hole in the

bottom of table. Place a 7/16" flat washer onto a 7/16-

14x1" hex head screw (F) Fig. 3, insert the screw through

the hole in the leg, and thread the screw into the hole in

the bottom of the table. Repeat this process for the three

remaining legs. NOTE: End of leg that has two square

holes (G) and one round hole (H) is to be fastened to

bottom of table, as shown. Do not completely tighten

hardware at this time.

Fig. 3

Fig. 4

Fig. 5

2. Assemble back panel (T) and two side panels (U) to

the inside of the four legs, as shown in Fig. 4. Align the

holes in the back panel and the side panels, with the

holes in the legs. Insert a 5/16-18x5/8" carriage head

bolt through the hole in the leg and the hole in the panel.

Place a 5/16" flat washer onto the carriage head bolt,

place a 5/16" lock washer onto the carriage head bolt,

thread a 5/16-18 hex nut onto the carriage head bolt and

tighten securely. Repeat this process for the 11

remaining holes in the panels and legs. NOTE: Firmly

tighten all leg and panel mounting hardware.

3. Place the front panel so the label is facing you in the

upright position. Assemble latch assembly to the right

side of the front panel by inserting threaded end of stud

(V) Fig. 5, through hole (W), place rubber bushing (X) on

threaded stud, thread special nut (Y) onto stud.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Delta 43-355 Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools Delta 43-355