Delta 43-355 Instruction Manual download pdf (Page 7)

Fig. 6

Fig. 8

Fig. 7

Fig. 9

Fig. 10

4. Assemble 3/8" rubber grommet (Z) Fig. 6, to round

hole (A) in leg.

5. Assemble front panel (B) Fig. 7, to the outside of the

two front legs. Insert a 5/16-18x5/8"" carriage head bolt

the hole in rubber grommet (Z) Fig. 6. Place a 5/16" fIat

washer (D) Fig 6, on the carriage head bolt, and thread a

5/16-18 lock nut (E) Fig. 6, on the carriage head bolt and

tighten the lock nut just enough, for the nut to start to

compress the rubber grommet (Z).

6. Lift up latch (F) Fig. 7, insert stud on inside of latch

into round hole in leg (G), and press down to lock latch

(F).

NOTE: If the rubber bushing of the latch will not line up

with the hole in the leg it will be necessary to loosen the

one 7/16-14x1" hex head screw attaching the leg to the

bottom of the table, and repositioning the leg so that the

hole in the leg and the stud on the latch will line up.

NOTE: The special nut on the latch should be tightened

to a point that it will compresses the bushing just

enough so that the bushing will pass through the hole in

the leg.

7. Assemble bottom shelf (G) Fig. 8 to the four legs (H)

(one of which is shown). Align the eight holes in the legs

with the eight holes in the shelf. Insert a 5/16-18x5/8"

carriage head bolt through the hole in the leg and the

hole in the shelf. Place a 5/16" flat washer onto the

carriage head bolt, place a 5/16" lock washer onto the

carriage head bolt, thread a 5/16-18 hex nut onto the

carriage head bolt and tighten securely. Repeat this

process for the seven remaining holes.

ASSEMBLING

SWITCH ARM

1. Place a 3/8" flat washer on a 5/16-18x1-3/4" hex

head screw (C) Fig. 9, and insert screw (C) through hole

in bottom of switch arm (D), as shown.

2. Fasten switch arm (D) Fig. 9, to bracket (A) by insert-

ing screw (C) through hole (G) and fasten in place with a

5/16-18 hex nut. NOTE: Switch arm (D) will be mounted

in the horizontal position, as shown in Fig. 10, and pro-

trusion (E) Fig. 9, on switch arm will be in hole (F) Fig. 9,

of switch plate. See section CHANGING POSITION OF

SWITCH ARM for instructions on moving arm to the

vertical position.

3. Turn shaper right side up.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Delta 43-355 Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Power tools Delta 43-355