Delta DP300 Instruction Manual download pdf (Page 11)

FASTENING DRILL PRESS TO

SUPPORTING SURFACE

If, during operation, the machine has a tendency to tip

over, slide, or walk on the supporting surface, secure the

machine base to the supporting surface with an

M8x1.25x125mm carriage head screw, 8.5mm flat

washer, 8.5mm lock washer, M8x1.25 hex nut through

the two holes (A) Fig. 19 located in the machine base.

STARTING AND STOPPING THE

MACHINE

The switch (A) Fig. 20 is located on the front of the drill

press head. To turn the drill press “ON”, move the

switch up. To turn the drill press “OFF”, move the

switch down.

Fig. 19

OPERATING CONTROLS AND ADJUSTMENTS

LOCKING SWITCH IN THE

“OFF” POSITION

IMPORTANT: When the machine is not in use, the

switch should be locked in the “OFF” position to

prevent unauthorized use. Grasp the switch toggle (B)

and pull it out of the switch (Fig. 21). With the switch

toggle (B) removed, the switch will not operate.

However, should the switch toggle be removed while

the drill press is operating, the switch can be turned

“OFF” once, but cannot be restarted without inserting

the switch toggle (B).

Fig. 20

Fig. 21

FLEXIBLE LAMP

The flexible lamp operates independently of the drill

press. To turn the lamp “ON” and “OFF”, rotate switch

(A) Fig. 22.

To reduce the risk of fire, use 40 watt or

less, 120 volt, reflector track-type light

bulb (not supplied). DO NOT use a

standard household light bulb. The

reflector track-type light bulb should not

extend below the lamp shade.

Fig. 22

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Delta DP300 Instruction Manual Page 11