Delta DP300 Instruction Manual download pdf (Page 13)

SPINDLE MOTOR

3100

2340

1720

1100

620

SPINDLE SPEEDS

Five spindle speeds (620, 1100, 1720, 2340, and 3100 RPM) are available with your drill press. See the chart in Fig. 28

to select the correct belt placement for your project.

CHANGING SPEEDS AND ADJUSTING BELT TENSION

NOTE: A belt-positioning speed chart (E) Fig. 29 is located on the inside top cover of the drill press.

1. Open the top cover (A) Fig. 29.

2. Loosen the tension lock knob (B) Fig. 29 to release belt tension. Pivot the motor (D) toward the front of the drill

press.

3. Hold the motor in this position and place the belt (C) on your selected speeds according to the chart in Fig. 28.

4. Move the motor to the rear until the belt has proper tension.

NOTE: The belt should be just tight enough to prevent slipping. Excessive tension will reduce the life of the belt, pulleys

and bearings. Correct tension is obtained when the belt (C) can be flexed about 1" out of line midway between the

pulleys using light finger pressure.

5. Tighten the tension lock knob (B).

Fig. 28

DISCONNECT MACHINE FROM POWER SOURCE.

DRILLING HOLES TO DEPTH

A depth stop is provided in the pinion shaft housing to

allow you to drill any number of holes to the same depth.

To use:

1. Insert the bit into the chuck.

2. Lower the spindle until the pointer (C) Fig. 30 aligns

with the your selected mark on the scale (D).

3. Tighten the lock screw (A).

4. Return the spindle to the up position.

5. Place the workpiece on the drill press table. Raise

the drill press table until the workpiece touches the

drill bit.

6. Drill a test hole to check the depth.

NOTE: Scale (D) is calibrated in both inches and

millimeters.

DISCONNECT MACHINE FROM POWER

SOURCE.

Fig. 29

Fig. 30

1 2 ... 8 9 10 11 12 13 14 15 16 17

No comments

Delta DP300 Instruction Manual Page 13