Delta JT160 Instruction Manual download pdf (Page 12)

ASSEMBLING FENCE

CARRIAGE ASSEMBLY

1. Remove the two M10x1.5x30mm hex socket head

screws (A) Fig. 11, and 10mm flat washers from the

back of the jointer base at location (C).

2. Align the two holes (B) Fig. 11, in the fence carriage

assembly, with the two tapped holes (C) in the back

of the jointer base. Insert the M10x1.5x30mm hex

socket head screw with a 10mm flat washer, through

the hole in the fence carriage assembly and thread

the screw into the tapped hole in the back of the

Jointer base. Repeat this process for the remaining

hole in the fence carriage assembly and the tapped

hole in the back of the Jointer base. NOTE: THE

TOP SURFACE (D) FIG. 12, OF THE FENCE

CARRIAGE ASSEMBLY MUST BE LEVEL WITH

THE TOP SURFACE (E) OF THE OUTFEED

TABLE. Once the fence carriage assembly is level

with the outfeed table, tighten the two screws (A)

Fig. 11 securely with an 8mm hex wrench.

Fig. 11

Fig. 12

ASSEMBLING FENCE

1. Remove the two M8x1.25x30mm hex socket head

screws (F) Fig. 12.

2. Align the two holes, one of which is shown at (G) Fig.

13, in the fence with the two holes (H) Fig. 12, in the

fence carriage assembly. Insert the screw through

the hole in the fence and thread the screw into the

tapped hole in the fence carriage assembly and

tighten securely with a 6mm hex wrench. Repeat

this process for the remaining hole in the fence and

fence carriage assembly.

3. Thread the fence tilting handle (A) Fig. 14, into the

tapped hole (B) in the fence.

Fig. 13

Fig. 14

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

No comments

Delta JT160 Instruction Manual Page 12