Delta JT160 Instruction Manual download pdf (Page 13)

ASSEMBLING

CUTTERHEAD GUARD

Loosen set screw (A) Fig. 16. Insert post (B) of the

cutterhead guard into hole in infeed table and tighten set

screw (A) against the flat on post (B).

MAKE CERTAIN THAT GUARD

OPERATES FREELY AND DOES NOT BIND OR

HANG-UP. ALWAYS CHECK GUARD OPERATION

BEFORE TURNING ON JOINTER.

Fig. 16

ASSEMBLING

RABBETING LEDGE

1. Remove the two M6x1x20mm socket head screws

Jointer.

2. Align the two holes (A) Fig. 15, in the rabbeting

ledge, with the two holes (B) in the front of the

Jointer. Insert the screw through the hole (A) in the

rabbeting ledge and thread the screw into the

tapped hole (B) in the front of the Jointer. Make sure

the rabbeting ledge is level with the infeed table.

Tighten screw (C) securely. Repeat this process for

the remaining hole in the rabbeting ledge and the

front of the Jointer.

Fig. 15

ASSEMBLING DUST CHUTE

The jointer stand has a built-in dust chute (A) Fig. 16A. If

this machine is to be used with a dust collection system,

the supplied dust collector connector (B) Fig. 16A, can

be fastened to jointer stand (C) with four #10-16x1/2"

hex head screws (not shown).

A standard 4" dust collection hose can be attached to

dust collector connector.

Fig. 16A

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

No comments

Delta JT160 Instruction Manual Page 13