Delta JT160 Instruction Manual download pdf (Page 24)

12. Lower the infeed table and place a straight edge (J)

Fig. 53, on the outfeed table extending over the

cutterhead as shown.

13. Rotate the cutterhead by hand until the knife is at its

highest point at each end of the cutterhead

. To raise

the knife, use wrench (E) Fig. 53, and turn raising

screw clockwise until the knife just touches the

straight edge (J) on each end and center of the

cutterhead when the knife is at its highest point.

When you are certain the knife is adjusted properly,

tighten the four locking screws (B) Fig. 49, by turning

them counterclockwise.

14. Adjust the remaining two knives in the same manner.

MAKE CERTAIN THAT ALL KNIVES ARE

SECURELY FASTENED IN CUTTERHEAD

BEFORE TURNING ON POWER.

15. Replace cutterhead guard.

Fig. 53

1 2 ... 19 20 21 22 23 24 25 26 27 28

No comments

Delta JT160 Instruction Manual Page 24